The following manual provide important instructions to correctly assemble the model. It is structured in a logical way, based on
the work done in previous step. If you change the order, it may result in additional or unnecessary steps. So we suggest you to
read this user manual very carefully to understand correctly the assembly procedure. Failure to do so may not only downgrade
performances but also increase the risk of danger. Apply thread lock as indicated, allow the threadlock to cure before mounting
parts. It is recommended to use threadlock on each bolt or screw that are engaged with metal parts.

•Brushless electric motor: 6s Lipo - 1200KV
(4mm Bolt holes, 30mm mount width, 6mm * 37mm motor shaft)

•Speed controller: minimum 120A (ESC specs limits should be rated accordingly to the maximum amps handling by the motor)

•Lipo Batteries: 6s 5000-5500 mAh •Electronic flybarless system

•3 pcs Metal standard servo's / 3 pcs Metal medium sized servo's

•1 tail rotor servo, standard size, high speed required

•550 mm main rotor blades

•92 mm tail rotor blades(included)

•6 channel or more helicopter transmitter system, 2.4 Ghz frequency preferred

•Receiver 6 channel or more (working with your transmitter specs)