NZD
USD
EURO
GBP
HKD
AUD
CAD
SGD
CHF
Product Description
KDS Agile A3 RC 2.4GHz Remote Controlled Helicopter Kit, No Blades
Specification:
Length：690mm
Height：200mm
Width：100mm
Main Rotor Diameter：Ø808
Main Blade Length：360mm
Tail Rotor Diameter：Ø169mm
Tail Blade Length：63mm
Motor Pinion：19T
Motor KV：2520-1880KV (Not included)
Driving Gear：(19/50)(15/66)
Gear Ratio：19T(11.57:1)
Tail Gear Ratio: 4.24:1
Flying Weight: 1100g
Battery：22.2V 1450-2000mAh (Not included)
ESC：60A (Not included)
Equipment Required for Assembly
RADIO TRANSMITTER AND ELECTRONIC EQUIPMENT REQUIRED FOR ASSEMBLY
•Brushless electric motor: 2520-1880KV
(3mm Bolt holes, 16-19mm mount width, 3.5mm motor shaft)
•Speed controller: minimum 60A
(ESC specs limits should be rated accordingly to the maximum amps handling by the motor)
•Lipo Batteries: 6s 1450-2000 mAh
•Electronic flybarless system
•3 pcs swashplate +1 pcs tail servo's
•360 mm main rotor blades (Not included)
•63 mm tail rotor blades (Not included)
•6 channel or more helicopter transmitter system, 2.4 Ghz frequency preferred
•Receiver 6 channel or more (working with your transmitter specs)
Introduction:
R/C helicopters, including the AGILE A-3 are not toys. R/C helicopters utilize various high-tech products and
technologies to provide superior performance. Improper use of this product can result in serious injury or even death.
Please read this manual carefully before using and make sure to be conscious of your own personal safety and the
safety of others and your environment when operating all AGILE products. Agile A-3, KDS Model, their affiliates and
authorized distributors are not responsible for personal injuries to the operators and others, and property damages that
could occur from the assembly, maintenance or your use/misuse of this product. Always respect the rules provided by
your local remote control aircraft organization.
The following manual provide important instructions to correctly assemble the model. It is structured in a logical way, based on
the work done in previous step. If you change the order, it may result in additional or unnecessary steps. So we suggest you to
read this user manual very carefully to understand correctly the assembly procedure. Failure to do so may not only downgrade
performances but also increase the risk of danger. Apply thread lock as indicated, allow the threadlock to cure before mounting
parts. It is recommended to use threadlock on each bolt or screw that are engaged with metal parts.
